CLI Reference Guide

4-10
System Messages
FIO-1.00-60: Too much cache is configured. The FIO.VLM file will
reduce the cache blocks by <number> blocks and load successfully.
Check the CACHE BUFFERS and BUFFER SIZE parameters in the
NET.CFG file; then load the FIO.VLM file.
Explanation: The amount of cache available in DOS is limited by
conventional memory. Neither of the parameters determining the amount of
memory to be used, CACHE BUFFERS nor BUFFER SIZE, can be
configured to use more than 64 KB of memory.
Action: Reduce the CACHE BUFFERS or BUFFER SIZE parameter in the
NET.CFG file. See Chapter 2, “NET.CFG Options Reference,” for more
information.
FIO-1.00-61: The IPX interface is not loaded. The FIO.VLM file will
load successfully without packet burst support. Load the IPXODI v2.00
or later to use packet burst or add PB BUFFERS=0 to the NET.CFG
file; then load FIO.VLM.
Explanation: This message is only a warning. The NetWare® DOS
Requester™ software functions properly without the use of the Packet
Burst™ protocol. Packet Burst, which is a part of the FIO.VLM file, requires
IPXODI.COM version 2.00 or later to function properly. No IPX™ interface
was loaded in this machine.
Action: If you want Packet Burst, make sure that IPXODI.COM version
2.00 or later is loaded before the NetWare DOS Requester. If you do not
want Packet Burst, add PB BUFFERS=0 to the NetWare DOS Requester
section of the NET.CFG file. See See Chapter 2, “NET.CFG Options
Reference,” for more information.
FIO-1.00-62: The LSL interface is not loaded. The FIO.VLM file will
load successfully without packet burst support. Load the LSL module
or add PB BUFFERS=0 to the NET.CFG file; then load FIO.VLM.
Explanation: This message is only a warning. The NetWare® DOS
Requester™ software functions properly without the use of the Packet
Burst™ protocol. Packet Burst, which is a part of the FIO.VLM file, requires
the LSL.COM file to be loaded to function properly.