CLI Reference Guide

4-8
System Messages
Action: Delete unnecessary files from the hard disk.
DOSCLINST-1.0-3: The INSTALL.OVL file could not be found.
Explanation: The INSTALL.OVL file could not be found. This file is an
integral piece of the INSTALL utility; it must be in the same directory as the
INSTALL.EXE file.
Action: Make sure that INSTALL.OVL is in the same directory as the
INSTALL.EXE file; then run INSTALL again.
DOSCLINST-1.0-4: A read error occurred while the program was
reading INSTALL.OVL.
Explanation: The file INSTALL.OVL has been corrupted. The INSTALL
utility requires INSTALL.OVL for successful installation.
Action: Copy INSTALL.OVL from the master diskettes to the same
directory as the INSTALL.EXE file; then run INSTALL again.
FIO-1.00-1: The message file <name> is invalid. The program cannot be
loaded.
Explanation: The .MSG file is invalid. This problem could be the result of a
corrupted file, a bad translation, or an outdated file version.
Action: Either update the .MSG file with a valid copy or delete the file. The
NetWare® DOS Requester™ software uses the default messages that are
bound to the binary files.
FIO-1.00-5: <Module1>.VLM is not loaded. The <module2>.VLM file
cannot be loaded before <module1>.VLM. Load the <module1>.VLM
file first then try to load the <module2>.VLM file.
Explanation: The <module2>.VLM file requires that the <module1>.VLM
file be loaded first. Either the current configuration has <module1>.VLM
and <module2>.VLM loading out of order, or <module1>.VLM did not load
successfully.
Action: Make sure that <module1>.VLM is configured to load before
<module2>.VLM. To do this, change the load order of the VLM= parameter
in the NET.CFG file.
FIO-1.00-7: In order to load the <module3>.VLM, one of the following
VLMs must be loaded: <module1>.VLM, <module2>.VLM.