CLI Reference Guide

4-7
System Messages
CONN-1.00-51: An older version of the shell is loaded. The NetWare
Requester for DOS cannot be loaded. Unload the shell; then load the
NetWare Requester for DOS files.
Explanation: The NetWare® DOS Requester™ software cannot be loaded
with the NetWare shell. The NetWare shell has been loaded in your machine.
For NetWare shell compatibility.
Action: Type “NETX /U” to unload the NetWare shell. If the version of the
NetWare shell in use does not support the /U parameter, reboot the machine
without loading the NetWare shell. See Chapter 2, “NET.CFG Options
Reference,” for more information.
CONN-1.00-52: The NetWare DOS Named Pipes Extender is currently
loaded. The NetWare Requester for DOS cannot be loaded. Unload the
NetWare DOS Named Pipes Extender; then load the NetWare
Requester for DOS files.
Explanation: The NetWare® DOS Requester™ software cannot be loaded
after the NetWare DOS Named Pipes Extender.
To use both the NetWare DOS Requester and NetWare DOS Named Pipes
Extender, load the NetWare DOS Requester first.
Action: Type “DOSNP /U” to unload the DOS Named Pipes Extender; then
load the NetWare DOS Requester before reloading the DOS Named Pipes
Extender. See “Named Pipes Options” for more information about Named
Pipes parameters in the NET.CFG file.
DOSCLINST-1.0-1: <Filename> could not be installed.
Explanation: The indicated file could not be installed on the destination
drive because either the file was not found on the master diskettes or the
INSTALL utility was unable to write to the INSTALL directory.
Action: Make sure that the file is on the master diskettes. Also make sure
that the destination drive is not write-protected or has some other condition
that would prevent the indicated file from being copied.
DOSCLINST-1.0-2: This program requires more disk space.
Installation could not be completed.
Explanation: Adequate disk space is not available on the destination drive.
More space must be available for the installation to be completed.