CLI Reference Guide

4-3
System Messages
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
AUTO-1.00-43: There is a missing or invalid ON/OFF value for
‘<parameter>’ on line <number> of the configuration file. This entry
will be ignored. Correct the line specified in the configuration file before
continuing.
Explanation: The configuration file contains a parameter that is defined to
use either an ON or OFF value, but a different value or no value has been
specified. This invalid line is ignored by the configuration process.
Action: No action is required at this point. However, to avoid this message
the next time the VLM.EXE file is loaded, delete or correct the line specified
by the error message.
AUTO-1.00-45: The parameter specified for the following option was
out of range and has been adjusted.
Explanation: A configurable parameter has been configured too high or too
low to be valid. The parameter is specified on the line following the
message.
Action: Check and correct the parameter specified in the NET.CFG file. See
Chapter 2, “NET.CFG Options Reference,” for more information.
BIND-1.00-1: The message file <name> is invalid. The program cannot
be loaded.
Explanation: The .MSG file is invalid. This problem could be the result of a
corrupted file, a bad translation, or an outdated file version.
Action: Either update the .MSG file with a valid copy or delete the file. The
NetWare® DOS Requester™ software uses the default messages that are
bound to the binary files.
BIND-1.00-5: <Module1>.VLM is not loaded. The <module2>.VLM file
cannot be loaded before <module1>.VLM. Load the <module1>.VLM
file first then try to load the <module2>.VLM file.