CLI Reference Guide

2-67
NET.CFG Options Reference
NetWare DOS Requester Option
BROADCAST SEND DELAY=number
Sets the number of ticks the NetWare DOS Requester software waits
between performing any function.
Set this to a higher number if you are using slow links such as modem or
serial links on your network.
NOTE: Increasing this number decreases the response time of some utilities.
BROADCAST TIMEOUT=number
Sets the number of ticks the NetWare DOS Requester software waits
between broadcast retries.
Syntax
broadcast retries=number
Default 3
Range 1 to 255
Modules PNW.VLM
Example To enable a workgroup to display in the WGLIST utility
that is not reachable by using the default value, you could
place the following lines in your NET.CFG file:
netware dos requester
broadcast retries=10
Syntax
broadcast send delay=number
Default 0
Range 0 to 255
Modules PNW.VLM
Example To ensure that utilities find resources connected by a serial
cable, you could place the following lines in your
NET.CFG file:
netware dos requester
broadcast send delay=10