HP-UX Host Intrusion Detection System Release 4.1 Release Notes for HP-UX 11i v1 | HP-UX 11i v2 | HP-UX 11i v3

NOTE: If you have installed any software updates, some of these patches may already
be present on your systems. You can first install the HP-UX HIDS software and run
the /opt/ids/bin/IDS_checkInstall command to check the patches that you do
not need to download.
If you attempt to install a patch that is already there, the swinstall command will
note that fact and just install the other patches.
1. Log in as superuser (root) on the depot system; see “Create the Depot Directory”
(page 33).
2. Create a directory in which you can save the patches and make a temporary depot.
This procedure uses /var/tmp/idspatch_11i.
3. Go to the HP Support Website:
http://itrc.hp.com,
4. Click the link individual patches.
NOTE: You must be registered before you can download patches.
5. Using the instructions on the Web site, download the patches listed in Table 2-4
(for HP-UX 11iv1) or Table 2-5 (for HP-UX 11iv2) into /var/tmp/idspatch_11i.
NOTE: Note the following:
• Some patches might have dependency patches; patches that must be installed
first. Click the dependency links and download the dependency patches as
well.
• Some patches might be superseded. You can choose the patch listed in Table
2-4 (for HP-UX 11iv1), Table 2-5 (for HP-UX 11iv2), or the superseded patch.
6. Unpack the patch file sets into their separate depots:
# sh -c ’for i in /var/tmp/idspatch_11i/PH*; do sh $i; done’
34 Installation