HP-UX Host Intrusion Detection System Release 4.0 Release Notes for HP-UX 11i v1 | HP-UX 11i v2 | HP-UX 11i v3

Table 2-2 Software to Install (continued)
Administration SystemAgent SystemEvaluation or Dual
System
Software
NOYESYESHP-UX required kernel
patches
YESNOYESJ2SE 5.0
YESNOYESJava 5.0 patches
NOYESYESIDS-KRN
YESYESYESOpenSSL
Installation Summary
The following sections provide step-by-step instructions for updating to or
cold-installing HIDS Release 4.0. This section provides a summary of the tasks.
In addition to these Release Notes, you will need the Host Intrusion Detection System
Administrator’s Guide Software Release 4.0, for information on configuration and initial
startup.
1. Ensure that your administration and agent systems meet the requirements as
described in “Hardware and Software Requirements” (page 20).
2. If you are currently using release 2.x, follow the instructions in “When Updating
from Release 2.x ” (page 21).
3. Perform the preinstallation tasks described in “Preinstallation” (page 22).
4. Create software depots for the administration system and the agent systems, as
described in “Making Depots” (page 22).
5. Install the software on your administration and agent systems, as described in
“Installing the Depots” (page 33).
6. Perform the postinstallation tasks described in “Postinstallation” (page 34).
7. Create secure communication certificates and perform other configuration tasks,
as outlined in “Configuration” (page 35).
Hardware and Software Requirements
Check that your systems meet the requirements for installing HP-UX HIDS.
Administration and Agent Systems
Each administration and agent system must meet the following requirements:
• The administration and agent system must be running HP-UX 11i v1 HP–UX 11i
v2, or HP-UX 11i v3. To check, enter the following command:
20 Installation