Host Intrusion Detection System Release 3.1 Release Notes

Installation
Making Depots
37
Step 2. Insert the software CD into the appropriate drive if you are installing from the
Application Software CD. If you are downloading the software package from
http://www.software.hp.com, download the depot and follow the instructions
provided in the installation page of the OpenSSL software.
Step 3. Run the following command to install the OpenSSL software:
# swinstall -s <fully-qualified depot source path> OpenSSL
Step 4. Enter the drive mount point in the Source Depot Path field and click OK. Change
the Source Host Name, if required.
Step 5. Choose OpenSSL from the list of available software and choose Mark for Install
from the Actions menu.
Step 6. Choose Install from the Actions menu to start the installation.
Step 7. Click OK in the Install Analysis window when the Status field displays a Ready
message.
Step 8. Choose Yes to start the installation. The swinstall command loads the OpenSSL
files in approximately 3 to 5 minutes.
The swinstall command installs the OpenSSL A.00.09.07-d software in the /opt/openssl
directory.
IMPORTANT You cannot install OpenSSL A.00.09.07-d on a system containing the Internet
Express OpenSSL 0.9.7c software. If the Internet Express OpenSSL 0.9.7c
software is installed on your system, you must remove the Internet Express
OpenSSL 0.9.7c software before installing OpenSSL A.00.09.07-d.
On HP-UX 11i v1 systems that do not contain the /dev/random file, OpenSSL automatically
uses prngd to generate random numbers.