Host Intrusion Detection System Administrator's Guide Release 3.0

Network Node Screen
General Operations
Chapter 7
106
• Shift-left-click to add or remove contiguous entries, depending on the state of the
anchor entry. The anchor entry is unchanged.
If the anchor entry is selected, all intervening entries are selected. If the anchor
entry is not selected (e.g., was deselected by Ctrl-left-click), all intervening entries are
removed.
If the previous operation was Shift-left-click, the effect of the previous operation is
negated.
Searching for the Next Unseen Entry
To select the next unseen alert/error
Step 1. On Alerts/Errors tab of the Network Node screen, use one of:
• Choose the Actions > Next Unseen Alert/Error menu item
• Right-click in the list; select Goto Next Unseen Alert/Error from the menu
• Press Shift-F10
The search begins after the anchor entry. If an unseen entry is found, it is highlighted
and other selections are cleared. If only the current entry is unseen or there are no
unseen entries, there is no action.
Searching for a String
You can search for an entry in the list on the Alerts or Errors tab based on any string in
any column, displayed or not. The search string is case-insensitive.
Starting a Search
To start a search
On the Network Node screen,
Step 1. To bring up the Find dialog (Figure 7-3), do either of:
• Choose the Search > Find menu item
• Press Ctrl-F
Figure 7-3 Find Dialog
Step 2. Enter your search string in the data field.
Step 3. Click on OK to begin the search or Cancel to cancel the search.
The search begins in the next entry. If the string is found, the entry is highlighted and
other selections are cleared. If the string only exists in one entry, you get an error
message (click OK to go on).