Encrypted Volume and File System v2.2 Administrator Guide (777846-001, April 2014)

from one system and installing (importing) the volume and disk on another system. This section
describes the following procedures:
• “Exporting an EVS volume” (page 73)
• “Importing an EVS volume” (page 75)
NOTE: Do not use the procedures in this section to configure EVS volumes for use in an HP
Serviceguard cluster. For more information, see “Using EVFS with HP Serviceguard” (page 168).
Exporting an EVS volume
Use the following procedure to export an EVS volume. You can use this procedure to remove EVS
volume information from a system before moving the volume and disk to another system. If you
are using LVM, repeat the following procedure for each volume in the group before you execute
the vgexport command.
Exporting and importing EVS volumes 73