Encrypted Volume and File System v2.0 Release Notes

EVFS cannot decrypt the kernel or other data before the system boots.
CAUTION: Encrypting the boot disk can cause the boot disk to become unusable and
prevent you from booting the system.
— Dump devices.
— Swap space (swap devices or file swap space).
CAUTION: Encrypting swap space can cause the system to panic.
• EVFS does not automatically convert existing volume data to encrypted data. To encrypt
existing volume data, use the inline encryption feature in this release of EVFS.
CAUTION: If you improperly configure EVFS on a volume that already contains data, the
existing data will be unusable.
IMPORTANT: To use inline encryption, 3 MB of spare disk space are required at the end
of the volume, and the minimum volume size must be 4 MB. If the entire volume is used,
extend the volume using lvextend for LVM, or vxassist for VXVM.
• To mount a file system on an EVFS volume, EVFS must be enabled and transferring data to
and from the file system in cleartext (unencrypted). Therefore, any executable that uses file
system utilities to read or write data can operate only on cleartext data.
Network file sharing utilities, such as NFS, CIFS, FTP, or rcp, will transmit files in cleartext,
even if the original files reside on an EVFS volume.
• For EVFS volumes configured in EVS mode, to use a backup utility that performs incremental
backups or that backs up individual files, you must enable the EVFS volume. The backup
utility will read the data in cleartext, even if the original files reside on an EVFS volume. If
the target backup device is another EVFS volume, the target EVFS volume will re-encrypt
the data.
If the target backup device is a tape device or other non-EVFS device:
— You must back up the volume as a volume device (as a single unit), not as a file system
or group of files, to create encrypted backup media. You can create encrypted backup
media using block device utilities, such as dd.
— You cannot create encrypted backup media using file-based utilities with EVFS volumes
configured for EVS.
• Executing the command vxresize with the -F option can cause lost or corrupt data. For
more information and a workaround, see “vxresize -F Can Cause Data Loss or Corruption”
(page 13).
• Renaming VxVM volumes with EVFS enabled makes the volume unusable. For more
information and a workaround, see “Renaming VxVM Volumes with EVFS Enabled Makes
the Volume Unusable” (page 13).
• EVFS is not supported by SAM or SMH.
• The evfsadm trace command is intended for use by support personnel only. HP does
not support this feature on customer environments.
• During inline encryption, the volume is not accessible until the entire operation is completed.
• The Multi Volume File System feature of Veritas, which is not supported by EVFS.
• EVFS is currently available in English only.
• Secure Sessions limit: 16K secure sessions per system.
• Volume limit: 1023 encrypted volumes per system.
10 EVFS