Backing Up and Restoring Data on HP-UX EVFS Volumes Using HP OpenView Storage Data Protector 6.0

4. In the Destination property page, specify the target location where the backed up keys
must be restored, as shown in the following figure. You can restore the backed up keys to
the original location, a different location on the same client system, or a different client
system. In this test scenario, evfs6.hp.com was selected as the target client system,
where the backed up keys were restored.
5. Click Restore to initiate the restore session.
The Session Information message displays the status of the recovery and notifies the successful
recovery of data. You can also specify the warning and error message that must be displayed
during the restore session.
Verifying the Backup and Recovery of the Keys of an HP-UX EVFS Volume
To verify if the backup and restore operations in Test Scenario 3A and Test Scenario 3B are
successful, complete the following steps:
56