Dynamic Root Disk A.3.12.* Administrator's Guide

0 Success
1 Error
2 Warning
The drd sync command syntax is:
drd sync [-?] [-p] [-q] [-v] [-x extended option=value] [-x -?] [-X
option_file]
Options
-? Displays the usage message for a DRD command. This option cannot be used with other
options.
-p Displays the usage message for a DRD command. This option cannot be used with other
options.
-q Decreases the verbosity level by one each time it is specified. For example, -qq will reduce
the verbosity from the default value of 4 to 2. If both -x verbosity=5 and -qqq are
included on the command line, the effective verbosity is 2. The minimum verbosity level is 0.
(See also the -x verbosity option.)
-v Decreases the verbosity level by one each time it is specified. For example, -qq will reduce
the verbosity from the default value of 4 to 2. If both -x verbosity=5 and -qqq are
included on the command line, the effective verbosity is 2. The minimum verbosity level is 0.
(See also the -x verbosity option.)
-x extended_option=value
Sets the extended option to a value.
-x -?
Displays the list of possible -x (extended) options.
-X option_file
Gets the extended options from a file.
Extended options
The following extended options are available:
-x exclude_list=
The full path for a file containing fully qualified file system locations to be excluded from
synchronization, listed one per line, in addition to those described in drd-sync(1M). If the
location is a directory, the contents of the directory, including all subdirectories, are excluded.
Note, file names must NOT end with a space.
-x logfile=/var/opt/drd/drd.log
This is the path to the log file for this command. Each time DRD is run, this file will grow larger.
This can be changed, for example, to a month-specific location for easier archiving, off-host
backup, and rotation.
-x log_verbosity=4
(Default.) Specifies the level of log verboseness. Replace 4 with the following values:
0 Only ERRORS and the starting/ending BANNER messages.
1 Adds WARNING messages.
2 Adds NOTE messages.
3 Adds INFO messages (informational messages preceded by the * character.)
4 (Default) Adds verbose INFO messages.
5 Adds additional detailed INFO messages.
-x verbosity=3 (Default.)
Specifies the level of stdout/stderr verboseness. Replace 3 with the following values:
0 Only ERRORS and the starting/ending BANNER messages.
1 Adds WARNING messages.
2 Adds NOTE messages.
58 DRD commands