Dynamic Root Disk A.3.11.* Release Notes

QXCR1000950254: The drd clone command succeeds when a device file is missing
for a disk other than the clone target.
QXCR1000961233: Cloning a fully allocated LVM disk to an identical sized
target can fail due to space issues if the LVM parameters for extent size,
max physical vols, or max logical vols are set to non default values.
# /opt/drd/bin/drd clone -v -x overwrite=true -t /dev/dsk/c3t5d0
======= 07/02/08 13:16:04 EDT BEGIN Clone System Image (user=root)
(jobid=lccns166)
* Reading Current System Information
* Selecting System Image To Clone
* Selecting Target Disk
* The disk "/dev/dsk/c3t5d0" contains data which will be overwritten.
* Selecting Volume Manager For New System Image
* Analyzing For System Image Cloning
ERROR: Analysis of file system creation fails.
- Analysis of target fails.
- The analysis step for creation of an inactive system image failed.
- The following messages, including errors, were obtained during
analysis:
E:The total volume sizes in disk group: "drdroot" exceed the
available capacity by 32Mb.
E:The disk capacity available is not sufficient to create the
volume
"/" with the size specified (disk space is short by 32Mb). Reduce
the size of this volume (or other volumes that share the same disk
group), or use additional/larger disks.
.
* Analyzing For System Image Cloning failed with 1 error.
======= 07/02/08 13:16:16 EDT END Clone System Image failed with 1
error.
(user=root) (jobid=lccns166)
QXCR1000964506: When an 11.23 system is cloned and then updated to 11.31.
The clone can now be mounted from the updated 11.31 system and remain
bootable.
QXCR1000976296: The command "drd runcmd swlist -l depot" fails.
Drd is fixed to enable this, so drd runcmd can list the depots in the
depot registry at the time the DRD clone was created. Note, it is
preferable to focus on depots registered on the active system
because drd is being improved to use depots that are on the
active system and are not in the DRD clone.
QXCR1000983266: During "drd runcmd update-ux -s /depot", the
following message needs a space between "/opt/swm/bin/swm" and
"oeupdate": * Executing command: "/opt/swm/bin/swmoeupdate -s
/depot" The DRD message has been fixed to be: * Executing
command: "/opt/swm/bin/swm oeupdate -s /depot"
QXCR1000984246: Prior to the fix for QXCR1000984246, drd clone
may fail if the booted system was previously an inactive image
that was modified or listed repeatedly with drd runcmd. If it is
an LVM-managed root, the clone will produce messages similar to these:
ERROR: Cloning of source system image fails.
- Cloning the system image fails.
- Reading of command output fails.
- Could not read from file "/var/opt/drd/tmp/drd1UOWhrCb/wUHPy9pu":