HP-UX Directory Server 8.1 configuration, command, and file reference

2.3.8.3 nsDS5ReplicaBindDN
This attribute sets the DN to use when binding to the consumer during replication. The value of
this attribute must be the same as the one in cn=replica on the consumer replica. This may be
empty if certificate-based authentication is used, in which case the DN used is the subject DN
of the certificate, and the consumer must have appropriate client certificate mapping enabled.
This can also be modified.
DescriptionParameter
cn=ReplicationAgreementName, cn=replica, cn=suffixDN, cn=mapping tree, cn=config
Entry DN
Any valid DN (can be empty if client certificates are used)Valid Values
Default Value
DirectoryStringSyntax
nsDS5ReplicaBindDN: cn=replication manager, cn=configExample
2.3.8.4 nsDS5ReplicaBindMethod
This attribute sets the method to use for binding. This attribute can be modified.
DescriptionParameter
cn=ReplicationAgreementName , cn=replica, cn=suffixDN, cn=mapping tree, cn=config
Entry DN
SIMPLE, SSLCLIENTAUTH, SASL/DIGEST-MD5, or SASL/GSSAPI
The SIMPLE and SASL/DIGEST-MD5 bind methods require a DN and password.
Valid Values
SIMPLEDefault Value
DirectoryStringSyntax
nsDS5ReplicaBindMethod: SIMPLEExample
2.3.8.5 nsDS5ReplicaBusyWaitTime
This attribute sets the amount of time in seconds a supplier should wait after a consumer sends
back a busy response before making another attempt to acquire access. The default value is three
(3) seconds. If the attribute is set to a negative value, Directory Server sends the client a message
and an LDAP_UNWILLING_TO_PERFORM error code.
The nsDS5ReplicaBusyWaitTime attribute works in conjunction with the
nsDS5ReplicaSessionPauseTime attribute. The two attributes are designed so that the
nsDS5ReplicaSessionPauseTime interval is always at least one second longer than the
interval specified for nsDS5ReplicaBusyWaitTime. The longer interval gives waiting suppliers
a better chance to gain consumer access before the previous supplier can re-access the consumer.
Set the nsDS5ReplicaBusyWaitTime attribute at any time by using changetype:modify
with the replace operation. The change takes effect for the next update session if one is already
in progress.
DescriptionParameter
cn=ReplicationAgreementName, cn=replica, cn=suffixDN, cn=mapping tree, cn=config
Entry DN
Any valid integerValid Values
3Default Value
82 Core server configuration reference