HP-UX Directory Server 8.1 configuration, command, and file reference

2.3.7.1 nsDS5Flags
This attribute sets replica properties that were previously defined in flags. At present only one
flag exists, which sets whether the log changes.
DescriptionParameter
cn=replica, cn=suffixDN, cn=mapping tree, cn=config
Entry DN
One of the following:
0
Means no changes are logged.
1
Means changes are logged.
Valid Values
0Default Value
IntegerSyntax
nsDS5Flags: 0Example
2.3.7.2 nsDS5ReplicaBindDN
This multi-valued attribute specifies the DN to use when binding. Although there can be more
than one value in this cn=replica entry, there can only be one supplier bind DN per replication
agreement. Each value should be the DN of a local entry on the consumer server. If replication
suppliers are using client certificate-based authentication to connect to the consumers, configure
the certificate mapping on the consumer to map the subjectDN in the certificate to a local entry.
DescriptionParameter
cn=replica, cn=suffixDN, cn=mapping tree, cn=config
Entry DN
Any valid DNValid Values
Default Value
DirectoryStringSyntax
nsDS5ReplicaBindDN: cn=replication manager, cn=configExample
2.3.7.3 nsDS5ReplicaChangeCount
This read-only attribute shows the total number of entries in the changelog and whether they
still remain to be replicated. When the changelog is purged, only the entries that are still to be
replicated remain.
See “nsDS5ReplicaPurgeDelay” and “nsDS5ReplicaTombstonePurgeInterval” for more information
about purge operation properties.
DescriptionParameter
cn=replica, cn=suffixDN, cn=mapping tree, cn=config
Entry DN
-1 to maximum 32-bit integer (2147483647)Valid Range
Default Value
IntegerSyntax
nsDS5ReplicaChangeCount: 675Example
2.3 Core server configuration attributes reference 77