HP-UX Directory Server 8.1 configuration, command, and file reference

NOTE:
To use SSL and TLS communications, the referral attribute should be in the form
ldaps://server-location.
Start TLS does not support referrals.
For more information on managing referrals, see the "Configuring Directory Databases" chapter
in the HP-UX Directory Server administrator guide.
DescriptionParameter
cn=configEntry DN
Any valid LDAP URL in the form ldap://server-location
Valid Values
Default Value
DirectoryStringSyntax
nsslapd-referral: ldap://ldap.example.comExample
2.3.1.82 nsslapd-referralmode (Referral mode)
When set, this attribute sends back the referral for any request on any suffix.
DescriptionParameter
cn=configEntry DN
Any valid LDAP URL in the form >ldap://server-location
Valid Values
Default Value
DirectoryStringSyntax
nsslapd-referralmode: ldap://ldap.example.comExample
2.3.1.83 nsslapd-reservedescriptors (Reserved file descriptors)
This attribute specifies the number of file descriptors that Directory Server reserves for managing
non-client connections, such as index management and managing replication. The number of
file descriptors that the server reserves for this purpose subtracts from the total number of file
descriptors available for servicing LDAP client connections (See “nsslapd-maxdescriptors
(Maximum file descriptors)”).
Most installations of Directory Server should never need to change this attribute. However,
consider increasing the value on this attribute if all the following are true:
• The server is replicating to a large number of consumer servers (more than 10), and/or the
server is maintaining a large number of index files (more than 30).
• The server is servicing a large number of LDAP connections.
• There are error messages reporting that the server is unable to open file descriptors (the
actual error message differs depending on the operation that the server is attempting to
perform), but these error messages are not related to managing client LDAP connections.
Increasing the value on this attribute may result in more LDAP clients being unable to access
the directory. Therefore, the value on this attribute is increased, also increase the value on the
nsslapd-maxdescriptors attribute. It may not be possible to increase the
nsslapd-maxdescriptors value if the server is already using the maximum number of file
descriptors that the operating system allows a process to use; see the operating system
documentation for details. If this is the case, then reduce the load on the server by causing LDAP
54 Core server configuration reference