HP-UX Directory Server 8.1 configuration, command, and file reference

2.3.1.75 nsslapd-outbound-ldap-io-timeout
This attribute limits the I/O wait time for all outbound LDAP connections such as those established
for replication. The default is 300000 milliseconds (5 minutes). A value of 0 means that the
server does not impose a limit on I/O wait time.
DescriptionParameter
cn=configEntry DN
0 to the maximum 32-bit integer value (2147483647)Valid Range
300000Default Value
DirectoryStringSyntax
nsslapd-outbound-ldap-io-timeout: 300000Example
2.3.1.76 nsslapd-plugin
This read-only attribute lists the DNs of the plug-in entries for the syntax and matching rule
plug-ins loaded by the server.
2.3.1.77 nsslapd-port (Port number)
This attribute gives the TCP/IP port number used for standard LDAP communications. To run
TLS/SSL over this port, use the Start TLS extended operation. This selected port must be unique
on the host system; make sure no other application is attempting to use the same port number.
Specifying a port number of less than 1024 means the Directory Server has to be started as root.
The server sets its effective user to the nsslapd-localuser value after startup.
When changing the port number for a configuration directory, the corresponding server instance
entry in the configuration directory must be updated.
The server has to be restarted for the port number change to be taken into account.
DescriptionParameter
cn=configEntry DN
1 to 65535Valid Range
389Default Value
IntegerSyntax
nsslapd-port: 389Example
NOTE:
Set the port number to zero (0) to disable the LDAP port if the LDAPS port is enabled.
2.3.1.78 nsslapd-privatenamespaces
This read-only attribute contains the list of the private naming contexts cn=config, cn=schema,
and cn=monitor.
DescriptionParameter
cn=configEntry DN
cn=config, cn=schema, and cn=monitorValid Values
Default Value
52 Core server configuration reference