Reference Guide

172 Chapter 8
Diagnostic Messages
Error Messages
1091 MESSAGE Incorrect register %s used
with %s optional target
register must be %s.
CAUSE This opcode takes an optional
register operand as specified. The
register you used for this operand
was incorrect.
ACTION Use either the correct operand or no
operand.
1094 MESSAGE Value for %s must be in range
0..3
CAUSE The value supplied for the privilege
level was outside the legal range of 0
to 3.
ACTION Supply a valid value in the range 0 to
3 for the privilege level.
1095 MESSAGE Not enough operands for
instruction %s
CAUSE While parsing the operands for the
current instruction <inst>, the
assembler encountered the end of the
line while it was still expecting one or
more operands for the instruction.
ACTION Supply the missing operand(s).
1096 MESSAGE Missing completer for opcode
%s
CAUSE The instruction <inst> requires a
completer. For example the
instruction BB always requires a
completer (either < or >=); omitting
this completer will cause the
assembler to generate this error
message.
ACTION Inspect the current instruction for
missing completers and add the
appropriate completer.