HP WDB GUI 5.8 Reference Manual ( February 2008 )

Debugging with WDB GUI
Setting Signal Handling
Chapter 342
Viewing signal handling
To view how signals are handled
1. On the Edit menu, click Signals.
2. When you are finished, click Cancel to close the dialog box.
Changing signal handling
To change how a signal is handled
1. On the Edit menu, click Signals.
2. Click on the setting you want to change. Each setting toggles between Yes and No when
you click on it.
3. Once you have finished changing the settings, click Apply to commit your changes.
4. Click OK or Cancel to close the dialog box.
Tips: The signals, SIGINT and SIGTRAP,w are used by the debugger. It is not a good idea to
change how these signals are handled; doing so may cause the debugger to stop working.
Table 3-3 Buttions and descriptions
Button Description
OK Click to apply changes you have
made and exit this dialog box.
Apply Click to apply the changes that
you have made.
Cancel Click to exit this dialog box.
Changes that were not applied will
be lost.