HP WDB GUI 5.8 Reference Manual ( February 2008 )

Installing WDB GUI
Installation Overview
Chapter 220
Installation Overview
The following sections describe the requirement for installing WDB GUI:
Supported Configurations
HP WDB GUI 5.7 supports the debugging of programs written in HP C, HP aC++, and
Fortran 90 on Integrity systems running HP-UX 11i v2 or HP-UX 11i v3, and HP 9000
systems running HP-UX 11i v1, HP-UX 11i v2, or HP-UX 11i v3.
Disk Space Requirements
For information on disk space requirements, see the HP WDB release notes that are available
on the HP WDB Download Webpage at:
http://www.hp.com/go/wdb
Installation Instructions
WDB GUI requires HP WDB. If you do not have HP WDB 5.7 installed on your system, it will
be loaded automatically when you install WDB GUI 5.7.
Use the SD-UX swinstall command to install your software. It invokes a user interface that
leads you through the installation. It also gives you information about disk space
requirements, version numbers, product descriptions, and dependencies.
NOTE When you install the WDB GUI with swinstall, select both the WDB GUI and
WDB products. If you select only the WDB GUI product, the WDB
documentation does not load automatically.
For more information about swinstall, refer to the sd(5) man page, the swinstall(1m) man
page, or the online help in swinstall .
Filesets
The WDB-GUI product contains the following subproducts:
• Runtime contains one fileset: WDB-GUI-RUN
• Help contains one fileset: WDB-GUI-HELP