HP-UX Desktop Troubleshooting Guide

— Xaccess Configuration
The Xaccess file is either located at /etc/dt/config/ or
/usr/dt/config/.
In Xaccess file, the following lines must be uncommented:
◦ # grant service to all remote displays
CHOOSER BROADCAST # any indirect host can get a chooser
Check the Xaccess file in the /etc/dt/config directory first, then check in
the /usr/dt/config file.
# #########################################################################
# Entries...
* # grant service to all remote displays
#
# The nicest way to run the chooser is to just ask it to broadcast
# requests to the network - that way new hosts show up automatically.
# Sometimes, however, the chooser can't figure out how to broadcast,
# so this may not work in all environments.
#
* CHOOSER BROADCAST # any indirect host can get a chooser
# #########################################################################
Once the above-mentioned troubleshooting techniques are followed, the
dtlogin process must be stopped and restarted again by executing the
following commands:
# /sbin/init.d/dtlogin.rc stop
# /sbin/init.d/dtlogin.rc start
• Error message:
“Your XDMCP connection timed out”
There can be multiple reasons for the above message.
4.2 Troubleshooting Common Error Messages 15