Debugging with GDB Manual (5900-1473; WDB 6.2; January 2011)

8.10 Registers
You can refer to machine register contents, in expressions, as variables with names
starting with '$'. The names of registers are different for each machine. Use info
registers to view the names used on your machine.
info registers Print the names and values of all registers except
floating-point registers (in the selected stack
frame).
info all-registers Print the names and values of all registers,
including floating-point registers.
info registers regname ... Print the relativized value of each specified register
regname. As discussed in detail below, register
values are normally relative to the selected stack
frame. regname may be any register name valid
on the machine you are using, with or without the
initial '$'.
GDB has four standard register names that are available (in expressions) on most
machines―whenever they do not conflict with an architecture's canonical mnemonics
for registers. The register names $pc and $sp are used for the program counter register
and the stack pointer. $fp is used for a register that contains a pointer to the current
stack frame, and $ps is used for a register that contains the processor status. For example,
you could print the program counter in hex with
p/x $pc
or print the instruction to be executed next with
x/i $pc
or add four to the stack pointer
3
with
3
with
set $sp += 4
Whenever possible, these four standard register names are available on your machine
even though the machine has different canonical mnemonics, so long as there is no
conflict. The info registers command shows the canonical names. For example,
on the SPARC, info registers displays the processor status register as $psr but
you can also refer to it as $ps; and on x86-based machines $ps is an alias for the
EFLAGS register.
GDB always considers the contents of an ordinary register as an integer when the register
is examined in this way. Some machines have special registers which can hold nothing
but floating point; these registers are considered to have floating point values. There is
no way to refer to the contents of an ordinary register as floating point value (although
you can print it as a floating point value with 'print/f $regname').
3. This is a way of removing one word from the stack, on machines where stacks grow downward in memory
(most machines, nowadays). This assumes that the innermost stack frame is selected; setting $sp is not
allowed when other stack frames are selected. To pop entire frames off the stack, regardless of machine
architecture, use return; see “Returning from a function” (page 116).
8.10 Registers 91