Debugging Dynamic Memory Usage Errors Using HP WDB (5900-1474; WDB 6.2; January 2011)

Example 17 Collecting memory leak report using batch mode

To collect the memory leak report using batch mode, complete the following steps:

a. Compile the source file.

$ aCC -Ae -o memLeak -g memLeak.c

b. Set the target application to preload the librtc runtime library, enter the following

command at the HP-UX prompt:

$ chatr +rtc enable memLeak

c. Set an environment variable BATCH_RTC. If you are using the Korn or Posix

shell, enter the following command at the HP-UX prompt:

$ export BATCH_RTC=on

d. Enable the leaks detection for the application run and get the call stack by setting

the check_leaks variable as shown below.

$ cat rtcconfig

check_leaks=on

e. Run the program.

$ ./memLeak

The output of ./memLeak is as shown below:

a. Enter length of string 1

Allocating memory of size 20

Too small size for a string, not allocating

Number of badInput is 1

b. Enter length of string 1

Allocating memory of size 20

Allocating memory of size 35

c. Enter length of string 2

str1 <= str2

warning: Memory leak info is written to "memLeak.5944.leaks".

The memory leak report produced by batch rtc file is as shown below:

20 bytes leaked in 1 blocks

No. Total bytes Blocks Address Function

0 20 1 0x40061a00 allocateMemory()

-------------------------------------------------------------------------