Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Integrating DCE Services with HP Serviceguard
Chapter 6 77
Starting the Package on the Serviceguard Cluster
Configured packages are started automatically on their primary nodes
when the Serviceguard cluster is started. Packages on the Serviceguard
cluster can be halted manually. To restart a package, use SMH or follow
these steps.
1. To restart the package on a specified host, enter:
cmrunpkg -n host pkg-name
2. To re-enable packet switching after halting the package, enter:
cmmodpkg -n host pkg-name
Summary of DCE-HP Serviceguard Installation and
Configuration
The following steps summarize the process of installing and configuring
DCE with HP Serviceguard.
1. Install the HP Serviceguard cluster.
2. Start the HP Serviceguard cluster.
3. Identify and mount the shared volumes manually from the primary
node.
4. Identify the hostname and IP address to be dedicated for the DCE
package.
5. Manually activate the package IP address from the primary node
using the cmmodnet command.
6. Configure DCE Core Services.
7. When the above configurations are complete, the DCE daemons will
start up automatically. Stop them manually using dce_config.
8. Manually unmount and deactivate the shared volume.
9. Manually deactivate the package IP address from the primary node
using the cmmodnet command.
10. Configure the DCE package scripts.
11. Apply the Package Configuration on the ServiceGuard cluster.
12. Start the ServiceGuard cluster.