Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Integrating DCE Services with HP Serviceguard
Chapter 6 71
Supported Templates for HP Serviceguard
Integration with DCE
As part of the DCE product, HP-UX DCE 2.0 provides a fileset
(DCE-SGUARD) that contains a set of customizable Serviceguard
templates and scripts to integrate HP Serviceguard with DCE services.
This set of templates includes the DCE processes dced, cdsadv, secd,
and cdsd within a single package. Each process is monitored separately,
and local restart and local network switchover are supported.
NOTE Do not attempt to use the templates in an installation without first
customizing them.
NOTE This section includes information about the HP-UX DCE server.
However, DCE Server is not available on HP-UX 11i v3. Use the
information in this section to integrate DCE 2.0 clients and older DCE
Servers (running on HP-UX 11i v1 and HP-UX 11i v2) with HP
Serviceguard.
The templates and scripts are as follows:
dcepkg.conf—package definition file generated by HP
Serviceguard. You must supply the Serviceguard node names, DCE
services, and the network name and address.
rc.dcepkg—package control script generated by HP Serviceguard.
You must supply the Serviceguard node names, DCE services, and
the network name and address. You can also specify customer
defined functions.
dce—DCE configuration file, which is copied from
/etc/rc.config.d/dce to the DCE/Serviceguard package directory.
You can set the environment variable RPC_SUPPORTED_NETADDRS to
the package IP address.
dce.start—package startup script, which HP Serviceguard calls
when the package is activated.
dce.restart—package restart script, which the DCE service
monitor uses to start an individual DCE service.