Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Configuring Cells Using dce_config
Chapter 666
is updated to include DCED_SWITCHES= -r. You can also set
REMOTE_ADMIN in the config.env file if you run dce_config non-
interactively.
• REMOVE_PREV_INSTALL: Set to y to remove all remnants of previous
DCE installations for all components before installing a security
server. Use only in installing the security server software. Default is
n.
• REMOVE_PREV_CONFIG: Set to y to remove all remnants of previous
DCE configurations for all components before configuring a client or
an initial CDS server. Default is n.
• REP_CLEARINGHOUSE: Name for new clearinghouse.
• SEC_SERVER: Name of the security server for this cell.
• SEC_SERVER_IP: IP address for $SEC_SERVER.
• SYNC_CLOCKS: Set to y to synchronize client clock with that of the
security server; n otherwise. If not set, and clocks are out of sync by
more than $TOLERANCE_SEC, user is prompted for whether to
synchronize. This variable is irrelevant if CHECK_TIME is set to n.
• TOLERANCE_SEC: Number of seconds client node system clock is
allowed to differ from security server system clock before warning
that clocks are not in sync and allowing input to synchronize. Default
is 120 seconds. Note: Security and Cell Directory services require
less than a 5 minute difference between any two nodes in the cell.
• TP_DEV: Name of device to which Spectracom time source is attached.
Example: /dev/tty00.
• UID_GAP: Increment above highest currently-used UID at which the
Registry Service will start assigning automatically-generated UIDs.
Default is 100.
• UNCONFIG_HOST_PRESET: Host name of node to be unconfigured.