Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Configuring Cells Using dce_config
Chapter 6 63
• dce.unconfig hostname: Removes DCE client on hostname from
the Security and Directory service databases. Should be run before
reconfiguring DCE on a client system.
• dce_com_env: Sets common DCE environment variables.
• dce_com_utils: Common internal routines used by DCE utilities.
• dce_config_env: Sets common environment variables used by
dce_config.
• dce_config_utils: Common internal routines used by dce_config.
• /sbin/init.d/dce[start | stop]: Starts or stops HP-UX DCE
daemons. Cannot be run remotely; must be run on DCE client or
server node.
• /etc/rc.config.d/dce: Read by /sbin/init.d/dce to determine
which daemons to start.
dce_config Environment Variables
dce_config recognizes the following environment variables. If these
environment variables are set and exported before dce_config is run in
interactive mode, possible corresponding prompts for information will be
skipped.
• CACHE_CDS_SERVER: Name of a CDS server in cell to cache. Need not
be the initial CDS Server.
• CACHE_CDS_SERVER_IP: IP address of $CACHE_CDS_SERVER.
• CELL_ADMIN: Principal name of the Cell Administrator; either for an
existing cell or for a to-be-configured cell.
• CELL_ADMIN_PW: Password for the Cell Administrator, either for an
existing cell or for a to-be-configured cell.
• CELL_NAME: Name of your cell (without //).
• CHANGE_PW: This internal variable tracks whether dce_config
receives the warning "Password must be changed" to indicate the cell
administrator password is the same as the default password. Initial
value is n; do not alter this initial value.