Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Configuring Cells Using dce_config
Chapter 660
If you want to remove and reconfigure a client, first unconfigure and
remove the client from the cell, then reconfigure the client. You may
remove and reconfigure a client without reconfiguring the other
members of a cell.
NOTE You cannot use the dce_config UNCONFIGURE option to remove a
Master Security Server or Initial Directory Server system from a cell.
You must either use the DCM to do this, or reconfigure the entire cell.
You can use the dce_config UNCONFIGURE option to remove
Additional CDS Server or Replica Security Server systems from a cell.
1. On the system you want to affect, run dce_config.
2. Select REMOVE from the DCE Main Menu:
DCE Main Menu (on hostname)
selection: 5 (REMOVE)
Attempting to stop all running DCE daemons...
Successfully stopped all running DCE daemons...
Attempting to remove all remnants of previous DCE
configurations...
Successfully removed all remnants of previous DCE
configurations for all components...
Re-initializing the dce_config environment
3. If you are unconfiguring an entire cell, repeat steps 1 and 2 on each
cell member.
4. If you want to reconfigure the cell, do so as described starting with
the section “Initial Cell Configuration” on page 50". Reconfigure the
cell only after you have run the REMOVE option on each cell
member.
dce_config Error and Message Logging
dce_config and its component scripts write log messages containing
errors, warnings, action summaries, and action details. Some log
messages are written to stdout; log messages are also written to
/var/opt/dce/config/dce_config.log.