Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Configuring Cells Using dce_config
Chapter 658
NOTE If you want to enable auditing, you must explicitly start the audit
daemon by selecting 9 (Auditing) from the dce_config "Additional
Server Configuration" menu. Not starting the audit daemon is
functionally equivalent to setting DCEAUDITOFF, effectively disabling
auditing.
If you want to disable auditing completely, set the DCEAUDITOFF
environment variable to 1 on each node where you intend to run a DCE
server before starting the cell's servers.
Removing Systems from the Cell
NOTE You cannot use the dce_config UNCONFIGURE option to remove a
Master Security Server or Initial CDS Server system from a cell. You
must either use the DCM to do this, or reconfigure the entire cell. You
can use the dce_config UNCONFIGURE option to remove Additional
CDS Server or Replica Security Server systems from a cell.
To remove a configured system (except a Master Security Server or
Initial CDS Server system) from a cell, use the -UNCONFIGURE option
on the DCE Main Menu. The UNCONFIGURE operation can be
executed on any system in the cell. A prompt will ask for the name of the
system to be unconfigured. The UNCONFIGURE option removes the
target machine from the cell Security database and the CDS name space.
After you have unconfigured the system, run dce_config on the system
and use the REMOVE option from the DCE Main Menu.
DCE daemons must be running on the system executing the
UNCONFIGURE option. If daemons have been stopped, use the START
option on the DCE Main Menu to restart them before using
UNCONFIGURE.
A successfully configured client system can be unconfigured locally. If
there were any errors in configuring the client system as a security or
directory service client, then the client must be unconfigured from some
other system in the cell.
1. Start dce_config on the client system.