Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Configuring Cells Using dce_config
Chapter 654
When dce_config is first run on a system, the HP-UX environment
variable TZ is read to determine the HP-UX local time zone.
dce_config then automatically selects a matching DCE local time
zone and creates the link for /etc/opt/dce/zoneinfo/localtime.
A different time zone can be chosen: see the localtime (5) manpage
for details.
To configure a DTS server on this system, or on another system:
• If the DTS server for this cell will be on another system, repeat
steps 1 and 2 on that system, and continue with step 11 below.
• If the DTS server will be on this system, continue with step 11
below.
11. From the Initial Cell Configuration menu, choose Initial DTS Server:
selection: 3
S:****** Configuring initial DTS services
S:******Please wait for user authentication and
authorization...
S:****** Checking for active sec_client service...
DTS Configuration Menu
1. DTS Local Server
2. DTS Global Server (only in multi-LAN cells.)
3. DTS Clerk
4. DTS Time Provider
98. Return to previous menu
99. Exit
selection:
12. For servers on the same LAN, select the DTS Local Server:
selection: 1 (DTS Local Server)
For a discussion about the use of DTS global servers for time servers
communicating between LANs, see the OSF DCE Administration
Guide. Where appropriate, select the DTS global server:
selection: 2 (DTS Global Server)
Either selection starts the dts daemon (dtsd).
13. Configure a DTS time provider on one of the time servers in a cell.