Planning and Configuring HP-UX DCE 2.0

Configuring HP-UX DCE Cells
Configuring Cells Using dce_config
Chapter 6 51
DCE Configuration Menu (on hostname)
1. Initial Cell Configuration
2. Additional Server Configuration
3. DCE Client4. DFS Client
98. Return to previous menu
99. Exit
selection:
2. From the DCE Configuration Menu, choose Initial Cell
Configuration:
DCE Configuration Menu (on hostname)selection:
1 (Initial Cell Configuration)
S:****** Configuring initial cell.Initial Cell
Configuration (on hostname)
1. Initial Security Server
2. Initial CDS Server
3. Initial DTS Server
98. Return to previous menu
99. Exitselection:
3. Configure the Security Server:
Initial Cell Configurationselection: 1 (Security Server)
S:****** Configuring initial Security Server
4. If this is your very first cell configuration, or if you have previously
run REMOVE, answer n to the following question. If you are
reconfiguring a cell, answer y:
Do you want to first remove all remnants of previous DCE
configurations for all components (y/n)?
You should do so only if you plan on reconfiguring all
existing DCE components now: (n)
5. Enter a cell name:
Enter the name of your cell (without /...), xyz.abc.com
S:****** Stopping rpcd...
S:****** Starting dced...
S:****** Initializing dced...
S:****** Since the glbd daemon was restarted and/or llbd
and rpcd were replaced by the endpoint mapper, NCS
applications may need to be restarted.
6. At the following prompt, enter any string and press < RETURN>.