Planning and Configuring HP-UX DCE 2.0

Installing HP-UX DCE 2.0
Loading HP-UX DCE Software in a Network Source Area
Chapter 544
NOTE If you are performing this install as a step in migrating a server
system from a previous version of HP-UX DCE, create a single depot
containing the HP-UX DCE 2.0 software and the DCE client software
that is bundled with HP-UX 11i v3. See Chapter 3, “Migrating to
HP-UX DCE 2.0,” on page 25 for information on migrating from a
previous HP-UX DCE version. The target depot path is the
pathname to the directory where you want the HP-UX DCE software
to be loaded. As a general rule, you should accept the HP-UX default
/var/spool/sw.
5. Specify the source hostname and source depot path in the Specify
Source popup window.
The source hostname is the name of the machine on which the media
device is mounted; the source depot path is the device pathname.
When you have specified these fields, a list of the products and
bundles available in that source depot (i.e., on the media) is
displayed in the Software Selection window.
6. Select the DCE products to load.
After you select (double-click on) the DCE bundle, a list of the DCE
products is displayed. Mark all the listed DCE products for loading.
7. Load the software into the depot.
Select Copy from the Actions menu.
If your software media was shipped with a codeword certificate,
follow the instructions on the certificate to obtain a codeword before
you load the software into the depot. Before you load software that
requires a codeword, you must enter a valid codeword and hardware
ID. If a codeword is not required for your software, answer "no" to the
question
Do you want to enter your authorized codeword to access the
protected software?