Planning and Configuring HP-UX DCE 2.0

Installing HP-UX DCE 2.0
Pre installation Planning
Chapter 5 41
5 Installing HP-UX DCE 2.0
This chapter outlines the recommended procedures for installing and
uninstalling HP-UX DCE Version 2.0 software.
If you are performing an upgrade rather than a new installation, see
Chapter 3, Migrating to HP-UX DCE 2.0, on page 25.
The procedures outlined in this chapter use the graphical and textual
user interface versions of the swcopy, swinstall, and swremove tools.
You can also use these tools from a command line.
See the manual Managing HP-UX Software With SD-UX and the swcopy
(1M), swinstall (1M) and swremove (1M) manpages for more
information on all aspects of installation.
After installing HP-UX DCE Version 2.0 software, you must configure a
DCE cell if you have not done so already, see Chapter 6, Configuring
HP-UX DCE Cells, on page 47.