Planning and Configuring HP-UX DCE 2.0

Migrating to HP-UX DCE 2.0
Migrating HP-UX DCE 1.9 on HP-UX 11i v2 to HP-UX DCE 2.0 on HP-UX 11i v3
Chapter 3 29
3. Prepare the network source area (depot) using swcopy. The depot
should contain both HP-UX 11i v3 and the HP-UX DCE 2.0 software.
4. Upgrade the system from HP-UX 11i v2 to HP-UX 11i v3. If you
installed from a unified network source area as recommended above,
installation of HP-UX DCE 2.0 is complete.
NOTE If you did not install from a unified network source area, you must
continue with Steps 5 through 7.
5. Stop DCE on the system, using the dce_config STOP command from
the main menu.
6. Install HP-UX DCE 2.0 as described in Chapter 4.
7. Restart DCE using the dce_config START command from the
dce_config main menu or using DMC.