Planning and Configuring HP-UX DCE 2.0

Migrating to HP-UX DCE 2.0
Migrating HP-UX DCE 1.9 on HP-UX 11i v2 to HP-UX DCE 2.0 on HP-UX 11i v3
Chapter 328
Migrating HP-UX DCE 1.9 on HP-UX 11i v2 to
HP-UX DCE 2.0 on HP-UX 11i v3
See Managing HP-UX Software with SD-UX and the swcopy (1M),
swinstall (1M) and swremove (1M) manpages for complete information
on all aspects of HP-UX installation.
Migrating a System Without Retaining Cell
Configuration
If you are migrating HP-UX DCE 1.9 to HP-UX DCE 2.0, but you do not
want to preserve your existing cell configuration, perform the following
steps:
1. Stop the cell using dce_config STOP at each cell member or run
DCM from SMH to stop the entire cell.
2. Use dce_config REMOVE or run the DCM from SMH to remove the
cell databases.
3. Upgrade the system from HP-UX 11i v2 to HP-UX 11i v3.
4. Install HP-UX DCE 2.0 software as described in Chapter 5,
“Installing HP-UX DCE 2.0,” on page 41 and reconfigure DCE.
NOTE You can migrate only the DCE client. DCE Server cannot be migrated.
Migrating a System and Preserving Current Cell
Configuration
If you are migrating HP-UX DCE 1.9 to HP-UX DCE 2.0, and you want
to preserve your existing cell configuration, perform the following steps:
1. If you are migrating a security server system, stop secd using the
dcecp -c registry stop replica-name command.
2. Stop DCE on the system, using the dce_config STOP command from
the main menu.