Planning and Configuring HP-UX DCE 1.9

Chapter 5

Installing HP-UX DCE 1.9

Pre installation Planning

5 Installing HP-UX DCE 1.9

This chapter outlines the recommended procedures for installing and uninstalling HP-UX DCE Version 1.9

software.

If you are performing an upgrade rather than a new installation, see Chapter 3, “Migrating to HP-UX DCE

1.9,” on page 25.

The procedures outlined in this chapter use the graphical and textual user interface versions of the swcopy,

swinstall, and swremove tools. You can also use these tools from a command line.

See the manual

Managing HP-UX Software With SD-UX

and the

swcopy (1M)

swinstall (1M)

and

swremove (1M)

manpages for more information on all aspects of installation.

After installing HP-UX DCE Version 1.9 software, you must conﬁgure a DCE cell if you have not done so

already, see Chapter 6, “Conﬁguring HP-UX DCE Cells,” on page 47.