Planning and Configuring HP-UX DCE 1.9

Chapter 3

Migrating to HP-UX DCE 1.9

Migrating HP-UX DCE 1.9 on HP-UX 11i v2 to HP-UX 11i v2 September 2004

Migrating HP-UX DCE 1.9 on HP-UX 11i v2 to HP-UX 11i v2 September

2004

See Managing HP-UX Software with SD-UX and the swcopy (1M), swinstall (1M) and swremove (1M)

manpages for complete information on all aspects of HP-UX installation.

Migrating a System Without Retaining Cell Conﬁguration

If you are migrating HP-UX DCE 1.9 to HP-UX DCE 1.9, but you do not want to preserve your existing cell

conﬁguration, perform the following steps:

1. Stop the cell using dce_config STOP at each cell member or run DCM from SAM to stop the entire cell.

2. Use dce_config REMOVE or run the DCM from SAM to remove the cell databases.

3. Upgrade the system from HP-UX 11i v2 to HP-UX 11i v2 September 2004 update.

4. Install HP-UX DCE 1.9 software as described in Chapter 4, and reconﬁgure DCE.

Migrating a System and Preserving Current Cell Conﬁguration

If you are migrating HP-UX DCE 1.9 to HP-UX DCE 1.9, and you want to preserve your existing cell

conﬁguration, perform the following steps:

1. If you are migrating a security server system, stop secd using the dcecp -c registry stop

replica-name

command.

2. Stop DCE on the system, using the dce_config STOP command from the main menu.

3. Prepare the network source area (depot) using swcopy. The depot should contain both HP-UX 11i v2

September 2004 update and HP-UX DCE 1.9 software.

4. Upgrade the system from HP-UX 11i v2 to HP-UX 11i v2 September 2004. If you installed from a uniﬁed

network source area as recommended above, installation of HP-UX DCE 1.9 is complete.

NOTE If you did not install from a uniﬁed network source area, you must continue with Steps 5

through 7.

5. Stop DCE on the system, using the dce_config STOP command from the main menu.

6. Install HP-UX DCE 1.9 as described in Chapter 4.

7. Restart DCE using the dce_config START command from the dce_config main menu or using DMC.