Planning and Configuring HP DCE 1.8

56 Chapter2
Migrating to HP DCE 1.8
Migrating an HP DCE 1.5 Server on HP-UX 10.20 to HP DCE 1.8 on
HP-UX 11i
CAUTION Hewlett-Packard recommends that you create a single network source
area (depot) containing HP-UX 11i and HP DCE 1.8 software, so you can
simultaneously install HP-UX 11i and HP DCE 1.8. If you do not install
HP-UX 11i and HP DCE 1.8 at the same time, your old HP DCE 1.5
servers will be automatically started when your system reboots after
HP-UX 11i installation completes. This is an unsupported configuration.
3. Prepare the network source area (depot) using swcopy. The depot
should contain both HP-UX 11i and HP DCE 1.8 software.
4. Upgrade the system from HP-UX 10.20 to HP-UX 11i If you installed
from a unified network source area as recommended above,
installation of HP DCE 1.8 is complete.
NOTE If you did not install from a unified network source area, you must
continue with Steps 5 through 7.
5. Perform this step only if you did not install HP-UX from a unified
network source area as recommended above.
Stop DCE on the system, using the dce_config STOP command from
the main menu.
6. Perform this step only if you did not install HP-UX from a unified
network source area as recommended above.
Install HP DCE 1.8. For more information about installing HP-UX
DCE 1.8, see Planning and Configuring HP DCE 1.8 (B3190-90074).
7. Perform this step only if you did not install HP-UX from a unified
network source area as recommended above.
Restart DCE using the dce_config START command from the
dce_config main menu or using DCM.