Planning and Configuring HP DCE 1.8

Chapter 5 101
Configuring HP DCE Cells
Configuring Cells Using dce_config
values, in priority order: ERROR, WARNING, SUMMARY, DETAIL,
VERBOSE, DEBUG.
• LOG_THRESHOLD: Minimum priority log messages from
dce_config that are written to /var/opt/dce/config/dce_config.log.
Default: DEBUG (all messages). ERROR, WARNING, and
SUMMARY messages are always logged. Possible values, in priority
order: ERROR, WARNING, SUMMARY, DETAIL, VERBOSE,
DEBUG.
• DEFAULT_MAX_ID: Maximum Unix ID value supported by DCE
Security Registry. Can be set to any value. Default value is 32767. A
value larger than the default prevents accounts with IDs larger than
32767 from accessing DCE cells that use the default. A value smaller
than the default prevents foreign accounts with IDs larger than
32767 from accessing the cell.
• DEFAULT_PW: Default password used when the registry is created.
Used only for logging in the cell administrator for the first time
(within dce_config). A cell administrator can change the default by
editing the value of DEFAULT_PW in the script. Default is -dce-.
• DIR_REPLICATE: Supports replication of additional directories
when configuring additional CDS Servers. If set to n, it will not
prompt if additional directories need to be replicated.
• DO_CHECKS: Set to n to prompt when a non-fatal warning is
encountered. Default is y.
• DOMAIN_NAME: The name of the host's Internet domain for use in
a fully qualified host name. Used as a default when configuring a
Kerberos client if /etc/resolv.conf does not already contain a domain
name. It is appended to the host name to get the fully qualified name
in this format: host_name.domain_name (for example: if
DOMAIN_NAME=foo.bar.com and host name=abc, the fully qualified
host name will be abc.foo.bar.com).
• EXIT_ON_ERROR: Set to y to exit from dce_config if a fatal error is
encountered. Default is n. This can prevent a here-document from
getting out-of-sync with dce_config.
• GID_GAP: Increment above highest currently-used GID at which the
Registry Service will start assigning automatically-generated GIDs.
Default is 100.
• HOST_NAME_IP: IP address of node on which dce_config is
running.