Planning and Configuring HP DCE 1.7

2-14 Planning and Configuring HP DCE 1.7
Migrating to HP DCE 1.7
Migrating an HP DCE 1.4.1 Server on HP-UX 10.10 to HP DCE 1.7 on HP-UX 11.0
1. If you are migrating a security server system, stop secd using the
dcecp -c registry stop replica-name command.
2. Stop DCE on the system, using the dce_config STOP command
from the main menu; DFS will not run on HP DCE 1.6 or 1.7; if DFS
is running, ignore any warnings concerning running processes.
CAUTION Hewlett-Packard recommends that you create a single network source
area (depot) containing HP-UX 11.0 and HP DCE 1.7 software, so you
can simultaneously install HP-UX 11.0 and HP DCE 1.7. If you do not
install HP-UX 11.0 and HP DCE 1.7 at the same time, your old HP DCE
1.4.1 servers will be automatically started when your system reboots
after HP-UX 11.0 installation completes. This is an unsupported
configuration.
3. Prepare the network source area (depot) using swcopy. The depot
should contain both HP-UX 11.0 and HP DCE 1.7 software.
4. Upgrade the system from HP-UX 10.10 to HP-UX 11.0. If you
installed from a unified network source area as recommended above,
installation of HP DCE 1.7 is complete.
NOTE If you did not install from a unified network source area, you must
continue with Steps 5 through 7.
5. Perform this step only if you did not install HP-UX from a unified
network source area as recommended above.
Stop DCE on the system, using the dce_config STOP command
from the main menu.
6. Perform this step only if you did not install HP-UX from a unified
network source area as recommended above.
Install HP DCE 1.7 as described in Chapter 4.
7. Perform this step only if you did not install HP-UX from a unified
network source area as recommended above.
Restart DCE using the dce_config START command from the
dce_config main menu or using DMC.