Planning and Configuring HP DCE 1.7

Planning and Conﬁguring HP DCE 1.7 2-13

Migrating to HP DCE 1.7

Migrating an HP DCE 1.4.1 Server on HP-UX 10.10 to HP DCE 1.7 on HP-UX 11.0

Migrating an HP DCE 1.4.1 Server on

HP-UX 10.10 to HP DCE 1.7 on HP-UX

11.0

See Managing HP-UX Software with SD-UX and the swcopy (1M),

swinstall (1M) and swremove (1M) man pages for complete information

on all aspects of HP-UX installation.

For information about migrating from HP-UX 10.x to HP-UX 11.0, see

Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 (B2355-90153).

Migration Procedures

HP highly recommends that you do a system backup before starting to do

an update.

Migrating a System Without Retaining Cell

Conﬁguration

If you are migrating an HP DCE 1.4.1 server on HP-UX 10.10 to HP DCE

1.7 on HP-UX 11.0, but you do not want to preserve your existing cell

conﬁguration:

1. Stop the cell using dce_conﬁg STOP at each cell member or run

DCM from SAM to stop the entire cell.

2. Use dce_conﬁg REMOVE or run the DCM from SAM to remove the

cell databases.

3. Upgrade the system from HP-UX 10.10 to HP-UX 11.0.

4. Install HP DCE 1.7 software as described in Chapter 4, and

reconﬁgure DCE.

Migrating a System and Preserving Current Cell

Conﬁguration

If you are migrating an HP DCE 1.4.1 server on HP-UX 10.10 to HP DCE

1.7 on HP-UX 11.0, and you want to preserve your existing cell

conﬁguration, perform the following steps: