Planning and Configuring HP DCE 1.7

2-2 Planning and Conﬁguring HP DCE 1.7

Migrating to HP DCE 1.7

Migration Paths

HP DCE 1.7 supports four direct migration paths from HP-UX 10.01,

10.10, 10.20, and 10.30 to HP-UX 11.0. Earlier versions of HP DCE that

run on versions of HP-UX before 10.01 can also be migrated to HP DCE

1.7, but not directly. The direct migraton paths are listed in Table 2-1.

Table 2-1 Supported Migration Paths to HP DCE Version 1.7

NOTE HP DCE 1.7 does not support direct migration from versions of HP DCE

that run on HP-UX 9.x (HP DCE 1.2, 1.2.1, and 1.4.2). However, you can

migrate from these versions by ﬁrst migrating to HP DCE 1.3.1 or 1.4 on

HP-UX 10.01 and then migrating that system to HP DCE 1.7 on HP-UX

11.0.

If you have HP DCE/9000 Version 1.3.1, 1.4, 1.4.1, 1.5, or 1.6 installed,

you can save your existing cell conﬁguration and databases, install HP

DCE/9000 Version 1.7, and then restore your former cell conﬁguration.

Or, you can discard your previous cell conﬁguration and database

information, update your systems to HP DCE 1.7, and conﬁgure a new

cell from scratch. Both procedures are detailed in this chapter.

From To

HP DCE Version Running on HP DCE Version Running on

1.3.1 or 1.4 client HP-UX 10.01 1.7 HP-UX 11.0

1.4 server HP-UX 10.01 1.7 HP-UX 11.0

1.4.1 server HP-UX 10.10 1.7 HP-UX 11.0

1.4.1 client HP-UX 10.10 1.7 HP-UX 11.0

1.5 server HP-UX 10.20 1.7 HP-UX 11.0

1.5 client HP-UX 10.20 1.7 HP-UX 11.0

1.6 server HP-UX 10.30 1.7 HP-UX 11.0

1.6 client HP-UX 10.30 1.7 HP-UX 11.0