Planning and Configuring HP DCE 1.7

Planning and Configuring HP DCE 1.7 5-27
Configuring HP DCE Cells
Configuring Cells Using dce_config
name. It is appended to the host name to get the fully qualified name
in this format: host_name.domain_name (for example: if
DOMAIN_NAME=foo.bar.com and host name=abc, the fully qualified
host name will be abc.foo.bar.com).
• EXIT_ON_ERROR: Set to y to exit from dce_config if a fatal error is
encountered. Default is n. This can prevent a here-document from
getting out-of-sync with dce_config.
• GID_GAP: Increment above highest currently-used GID at which the
Registry Service will start assigning automatically-generated GIDs.
Default is 100.
• HOST_NAME_IP: IP address of node on which dce_config is
running.
• HPDCE_DEBUG: Set to 1 starts daemons in the foreground.
• KEYSEED: Key seed for initial database master key.
• LAN_NAME: Internal name of the LAN (in the LAN profile) when
using multiple LANs. Use when configuring a CDS server.
• LOW_GID: Value at which the Registry Service will start assigning
automatically-generate d GIDs. Default is the value of the highest
currently used GID plus $GID_GAP. If $LOW_GID is less than or
equal to the highest currently used GID, a warning is issued, and
user is prompted to enter a new value (which can be the value of
$LOW_GID).
• LOW_UID: Value at which the Registry Service will start assigning
automatically-generated UIDs. Default is the value of the highest
currently used UID plus $UID_GAP. If $LOW_UID is less than or
equal to the highest currently used UID, a warning is issued, and
user is prompted to enter a new value (which can be the value of
$LOW_UID).
• MULTIPLE_LAN: Set to y to configure this node with multiple LAN
capability. Use when configuring a CDS server. Default is n.
• NTP_HOST: Host name on which the NTP server is running.
• TP_DEV: Name of device to which Spectracom time source is
attached. Example: /dev/tty00.