Planning and Configuring HP DCE 1.7

5-26 Planning and Configuring HP DCE 1.7
Configuring HP DCE Cells
Configuring Cells Using dce_config
• CHECK_TIME: Set to y to have time checked and possibly
synchronized; n otherwise. Default is y. If dce_config is executed
with a here-document, CHECK_TIME should be set to n since time
checking uses a telnet command that causes input from the
here-document to be lost.
• CONFIG_PROTSEQ: Communication protocol used for some
dce_config operations.This variable is set to ncadg_ip_udp by
default for use of the UDP protocol, which works in almost all cases.
Change to ncacn_ip_tcp only if TCP protocol routing is available.
• DISPLAY_THRESHOLD: Minimum priority log messages from
dce_config that are written to stdout. Default is SUMMARY.
ERROR and WARNING messages are always displayed. Possible
values, in priority order: ERROR, WARNING, SUMMARY, DETAIL,
VERBOSE, DEBUG.
• LOG_THRESHOLD: Minimum priority log messages from
dce_config that are written to /var/opt/dce/config/dce_config.log.
Default: DEBUG (all messages). ERROR, WARNING, and
SUMMARY messages are always logged. Possible values, in priority
order: ERROR, WARNING, SUMMARY, DETAIL, VERBOSE,
DEBUG.
• DEFAULT_MAX_ID: Maximum Unix ID value supported by DCE
Security Registry. Can be set to any value. Default value is 32767. A
value larger than the default prevents accounts with IDs larger than
32767 from accessing DCE cells that use the default. A value smaller
than the default prevents foreign accounts with IDs larger than
32767 from accessing the cell.
• DEFAULT_PW: Default password used when the registry is created.
Used only for logging in the cell administrator for the first time
(within dce_config). A cell administrator can change the default by
editing the value of DEFAULT_PW in the script. Default is -dce-.
• DIR_REPLICATE: Supports replication of additional directories
when configuring additional CDS Servers. If set to n, it will not
prompt if additional directories need to be replicated.
• DO_CHECKS: Set to n to prompt when a non-fatal warning is
encountered. Default is y.
• DOMAIN_NAME: The name of the host's Internet domain for use in
a fully qualified host name. Used as a default when configuring a
Kerberos client if /etc/resolv.conf does not already contain a domain