Planning and Configuring HP DCE 1.7

5-20 Planning and Configuring HP DCE 1.7
Configuring HP DCE Cells
Configuring Cells Using dce_config
5. Enter the principal name and password of the Cell Administrator for
your cell:
Enter Cell Administrator’s principal name:
(cell_admin)
Enter password:
dce_config deletes the registry entries and CDS entries for the
client, then displays the DCE Main Menu.
6. You must now perform the REMOVE option on the client system. If
you ran the UNCONFIGURE operation on a system other than the
client, start dce_config on the client system. On the client system,
select REMOVE from the DCE Main Menu:
selection: 5 (REMOVE)
7. The system explains that removing a node destroys the node’s ability
to operate in a cell, and asks if you want to continue:
Do you wish to continue (y/n)? y
The REMOVE option stops all running DCE daemons and removes
all previous configuration files on the local machine.
8. If you want to restart the client, follow the instructions in
“Configuring Client Systems: Security, CDS, and DTS”.
Removing and Reconfiguring the DCE
Daemons
This section describes how to remove and reconfigure the DCE daemons.
You will need to perform this procedure, for example, if you want to stop
a cell, if a configuration does not succeed, or if a server system crashes.
If you want to remove and reconfigure a client, first unconfigure and
remove the client from the cell, then reconfigure the client. You may
remove and reconfigure a client without reconfiguring the other
members of a cell.
NOTE You cannot use the dce_config UNCONFIGURE option to remove a
Master Security Server or Initial Directory Server system from a cell.
You must either use the DCM to do this, or reconfigure the entire cell.
You can use the dce_config UNCONFIGURE option to remove
Additional CDS Server or Replica Security Server systems from a cell.