HP DCE/9000 Version 1.7 for HP-UX 11.0 Release Note

HP DCE 1.7 for HP-UX 11.0 Release Note 33
Compatibility Information and Installation Requirements
HP DCE/9000 Version 1.7 Installation Requirements
• The operating system required for HP DCE 1.7: HP-UX 11.0.
• The memory space required to run HP DCE 1.7 is a minimum 32 Mb
of memory for client-only systems; 64 Mb for server systems.
• Disk space required to install HP DCE 1.7 is at least 92 Mb for a full
installation. (The exact space required is highly dependent on exactly
what is installed.)
• A minimum 100 Mb of swap space is recommended for client-only HP
DCE 1.7 systems; at least 150 Mb is recommended for systems
running one or more DCE servers. Device swap is strongly
recommended over file system swap.
• The HP-UX kernel parameter maxfiles must be increased to 256 and
the parameter maxuser must be increased to 64 for all systems.
maxdsize may have to be increased for some systems. See Planning
and Configuring HP DCE 1.7 for more information.
• HP DCE/9000 must be installed on a long-name file system. If you
have a short- name file system, you must first run convertfs(1m) to
convert your file system to long names.
You can check and, if necessary, change the kernel parameters, the swap
space, or both, via SAM (the HP-UX System Administration Manager).
For more information about HP DCE products and file sets, see Planning
and Configuring HP DCE 1.7.
Codeword
If your software media was shipped with a codeword certificate, you must
follow the instructions on the certificate to obtain a codeword before you
load the software into the depot. When you load software that requires a
codeword, you must enter a valid codeword and hardware id. If a
codeword certificate was not shipped with your software, answer “no” to
the question:
Do you want to enter your authorized codeword to access the
protected software?