HP-UX Secure Resource Partitions (SRP) A.02.02 Administrator's Guide

44
physical
memory
value is specified in megabytes.
Variable Name: prm_phys_mem.
Default: 0 (no dedicated physical shared memory).
8.1.3.2 Configuration Data
By default, SRP creates a new PRM group using the SRP compartment name as the PRM group name.
By default, the PRM group information is stored in the /etc/prmconf file. You can change the
filename by running the srp_setup utility, as described in 2 Setting Up an SRP.
8.1.4 The network Service
The network service configures an IP interface for the SRP compartment.
You do not have to use a dedicated network interface card for the compartment; you can create a
logical IP interface on a network interface card.
8.1.4.1 Input Data
SRP prompts for the following data. You can also specify a variable name and value in the command
line, as described in
15.1 Creating an SRP Compartment or Adding Data to an SRP.
IP address
Specifies the IP address for the compartment. You must specify an IP address not
currently configured on the system. Variable Name: ip_address.
Valid Input: An IPv4 address in dotted-decimal notation or an IPv6 address in
colon-hexadecimal notation.
Default: None.
Network
interface
name
Specifies the primary or secondary network interface name for the IP interface. A
primary network interface name has no IP index number or an IP index number set
to 0 (such as lan 2 or lan2:0). A secondary network name has a non-zero IP
index number (such as lan2:1). Secondary interfaces share the same physical
network interface as the corresponding primary interface. If you specify a primary
network interface that is already configured for IP, SRP configures a secondary
interface for you.
Variable Name: iface.
Default: None.
IP subnet
mask
(Valid for IPv4 addresses only) Specifies the subnet mask for the interface, in
dotted-decimal notation.
Variable Name: ip_mask.
Default: The network mask for the address class, as specified in the RFC 791 IETF
specification.
Default
gateway IP
Address
IP address to use for routing network packets for the configured compartment IP
address. The value is an IPv4 address in dotted-decimal notation or an IPv6
address in colon-hexadecimal notation.
Variable Name: gw_ip_address
Default: ip_addresss ( the IP address configured for this compartment)
Assign IP
address at
SRP start
time?
Configure the IP address in network configuration
file(/etc/rc.config.d/netconf or netconf-ipv6). Set this value to no if
the IP address assignmnent is managed by another subsystem, such as
Serviceguard.
Variable Name:
assign_ip