HP-UX Secure Resource Partitions (SRP) A.02.02 Administrator's Guide

21
##############################
#
# network configuration
#
##############################
Checking network strong ES model ... [ Enabled ]
Checking compartment IPv4 routing policy ... [ Enabled ]
Checking compartment IPv6 routing policy ... [ Enabled ]
Checking kernel tunable cmpt_allow_local ... [ Enabled ]
##############################
#
# sshd configuration
#
##############################
Checking sshd configuration ... [ OK ]
Enter sshd configuration file: [/opt/ssh/etc/sshd_config]
Saving SRP default template ... [ OK ]
Detected Init Compartment Secure Shell daemon listening on all IP
addresses.
Will conflict with any SRP Secure Shell daemons.
Would you like to restrict the Init compartment's sshd IP addresses? [y]
RETURN
Enter IP addresses, separated by comma ',': [15.146.224.214] RETURN
sshd will then listen on these interfaces:
ListenAddress 15.146.224.214
Would you like to save the changes to /opt/ssh/etc/sshd_config? [y]
RETURN
Changes saved to /opt/ssh/etc/sshd_config
Would you like to restart Init Compartment Secure Shell daemon? [y]
RETURN
Restarting sshd ... [ OK ]
##############################
#
# IPFilter Setup
#
##############################
Checking the IPFilter module ... [ Enabled ]
##############################
#
# IPsec configuration
#
##############################
Checking IPsec installation... [ OK ]
Checking IPsec status... [ Enabled ]