HP-UX Secure Resource Partitions (SRP) A.02.00 Administrator's Guide

(page 19). If so, srp_setup prompts if you want to configure a list of specific IP addresses in
the configuration file and displays a list of IP interface addresses configured on the system.
Detected Init Compartment Secure Shell daemon listening on all IP addresses.
Will conflict with any SRP Secure Shell daemons.
Would you like to restrict the Init compartment's sshd IP addresses? [y] RETURN
Enter IP addresses, separated by comma ',': [192.0.2.44] RETURN
sshd will then listen on these interfaces:
ListenAddress 192.0.2.44
Would you like to save the changes to /opt/ssh/etc/sshd_config? [y] RETURN
Changes saved to /opt/ssh/etc/sshd_config
##############################
#
# IPFilter Setup
#
##############################
Checking IPFilter module ... [ Enabled ]
##############################
#
# IPsec configuration
#
##############################
Checking IPsec installation... [ OK ]
Would you like to set/change IPsec password? [n]
Checking IPsec status... [ Enabled ]
Checking IPsec starts at boot-up... [ Enabled ]
##############################
#
# SRP setup completed.
#
##############################
28 Setting Up SRP